Hub Module    MiniPOD Heat Sink
              -----------------

Rev.  4-April-2017


Please mill the indicated fin height reduction and the fancy
MiniPOD hole shape in the blank MiniPOD Heat Sink bar stock.

This work is for Wade Fisher and is on account:  RC104022

Quantity:

  -  I would like just  2  MiniPOD Heat Sinks made first so
     that I can verify that the design is correct.  Verifying
     the design will require actually installed two MiniPODs
     onto a finished Hub Module circuit board.

  -  Then I would like  18  MiniPOD Heat Sinks made for the
     proto-type Hub Modules.  This will be in about one month
     or so.

  -  Then later this year Wade anticipates that we will be
     making about 20 more Hub Modules and they will require
     another  40  MiniPOD Heat Sinks at that time.


The details of the MiniPOD Heat Sink are indicated in the
attached 4 drawings.

  -->  Note that in about January or February of 2014 that
       Jim made a heat sink part very similar to this one.

       Specifically he carefully adjusted the shape of the
       fancy MiniPOD hole so that it exactly matched the
       part that must fit into that hole.

       This new current part needs to have exactly the same
       shape fancy hole in it but in this case the hole is
       rotated 90 degrees compared to the 2014 part.


Please call if there are any questions and I can run
right down to your shop to discuss things.

Thank you for your work on these parts,   Dan Edmunds