RMI Drip Detector to RPSS Setup and Operation ----------------------------------------------- Rev. 18-FEB-1994 The RMI located at the very top of M114 is used only for Drip Detection in the Level 1 racks M100 through M113. The other sensor input to this RMI are disabled. If this RMI detects a water leak and trips it will show up as an alarm in monitoring channel LV1FW_M114_4.DRIP ------------------- If this RMI trips it will also trip off all power to the Level 1 racks M100 through M114. This is done through the Level 1 Rack Power Safety System (the RPSS) which is located in the very bottom of rack M113. The source of an RPSS trip is shown by the LED's on the front panel of the RPSS. An RMI Drip Detector trip will show up as an "Air Flow" fault and a "Water Pressure" fault in rack M114. If this RMI Drip Detector does trip, please contact either Dan Edmunds or Dan Owen before resetting it and restarting the L1 system.