Cables to be manufactured at Fermilab for the D0 L1.5 Calorimeter Trigger project: This is the SECOND batch of cables to be made at FNAL: (1) DC-to-ERPB Parallel Timing Cables --------------------------------- Quantity: 12 Type: 40-conductor twist-n-flat Length: 10 "sections" (approximately 15 feet) Connectors: 10 40-contact "socket-style" cable mount connectors (with strain reliefs), mounted in the normal fashion (i.e. brown wire is pin #1 on every connector) See the diagram included with this document which provides details of spacing and orientation of the connectors on this cable Labels: the connector #1 end (see included diagram) of each cable should be labelled "DC-to-ERPB Parallel Timing Cable" Materials for these cables will be supplied by FNAL (2) DC --> top ERPB Daisy-Chain Cables ---------------------------------- Quantity: 10 Type: 50-conductor twist-n-flat Length: 1 "section" (approximately 20 inches) Connectors: one 50-contact "socket-style" cable mount connector (with strain reliefs) on each end, mounted in the normal fashion (i.e. brown wire is pin #1 on each end) Labels: each end should be labelled: "DC to top ERPB Daisy-Chain Cable" NOTE: These cables should be built with the following SIDE VIEW: .---- connector mating v surface .---- top of strain .---. v relief pin #1 marker ---->| | .---. _| |-. .-| |------------------------------------| |-' `-| |- `---' | |<---- pin #1 marker ^ top of strain `---' `---- relief ^ connector mating `---- surface Materials for these cables will be supplied by FNAL