; This file is DIST_00.seq    created 02-16-94    revised 03-02-94

; Note:  a bug in SEQ.C causes problems if a ; comment is not the only thing on the line,
;        so use a pair of colons around comments after non-comment characters.

CONVERT {
ADDRESS 0, 255
; ROM address          00000000000000001111111111111111222222222222222233333333333333334444444444444444555555555555555566666666666666667777777777777777
;                      0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef

    Q0: SQ_FAULT_CLK:  ~>
    Q1: SQ_FAULT_TOK:  ~>
    Q2: SQ_FSR_0_S0:   _>	:lo = hold, hi = shift:
    Q3: SQ_FSR_1_S0:   _>
    Q4: SQ_FSR_0_OE\:  ~>
    Q5: SQ_FSR_1_OE\:  ~>
    Q6: spare:         ~>
    Q7: spare:         ~>

} TO DU23_00.bit


CONVERT {
ADDRESS 0, 255
; ROM address          00000000000000001111111111111111222222222222222233333333333333334444444444444444555555555555555566666666666666667777777777777777
;                      0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef


    Q0: SQ_DDC0:       _~~~~~~~~~~~~~~~~~~ R16,7 __>	:Down Daisy Chain flag goes high ASAP:
    Q3: SQ_CLK_MASK:   ~~~________________ R16,7 ~~>	:Clock Mask is low for 128 clocks:
    Q4: SQ_FBACK0:     ~__________________ R16,7 ~~>	:Feedback keeps sequencer running after XMIT_TRIG goes inactive:

    Q1: SQ_DDC1:       ~>    :not used:
    Q2: SQ_ERPB_OE:    ~>    :ERPB's output is always enabled:
    Q5: SQ_FBACK1:     ~>    :not used:
    Q6: SQ_DST_1:      ~>    :not used:
    Q7: SQ_SPARE_OUT:  ~>    :not used:    

} TO DU26_00.bit