The following files were created at UCI in conjunction with the D0 L1.5
Calorimeter Trigger Upgrade.

Revised:  06-02-94


File            Format       Device         Description
------------    ---------    ----------     ------------------------------------------
    CONF.jed    Jedec        GAL16V8        LCA Configuration Board GAL

DIST1_00.jed    Jedec        GAL16V8        DC GAL1  (Setup GAL)
DIST2_00.jed    Jedec        GAL22V10       DC GAL2  (Selection GAL)
DIST3_00.jed    Jedec        GAL22V10       DC GAL3  (LCA configuration GAL)
DIST4_01.jed    Jedec        GAL22V10       DC GAL4  (transmit sequencer control GAL)

   TEG16.jed    Jedec        GAL16V8        Test ERPB 16V8  GAL (U35) (Fault GAL)
   TEG22.jed    Jedec        GAL22V10       Test ERPB 22V10 GAL (U34) (Transmit GAL)

ERPBX_00.jed    Jedec        GAL22V10       ERPB 22V10 GAL (U34) (Transmit GAL)

   ETEST.mcs    MCS-86       XC1736 (SCP)   ERPB LCA configuration for automated testing
   EBURN.mcs    MCS-86       XC1736 (SCP)   ERPB LCA configuration for burn-in
   E_RUN.mcs    MCS-86       XC1736 (SCP)   ERPB LCA configuration for running (version 0)

 DU23_00.mcs    MCS-86       7C291 (PROM)   DC transmit sequencer PROM (U23)
 DU26_00.mcs    MCS-86       7C291 (PROM)   DC transmit sequencer PROM (U26)



Notes:

TEG16.jed is used for testing and running.
TEG22.jed is used for testing; ERPBX_00.jed is used for running.

MCS-86 is the Intel hex format.

SCP = serial configuration PROM, typically used to hold an LCA configuration.

ERPB = Energy Readout Paddle Board for D0 trigger upgrade.

DC = Distributor Card for D0 trigger upgrade.

DIST = former abbreviation for DC

The configuration board is a small board containing a GAL, an SCP, and
miscellaneous logic.  It is used, in the absence of a distributor card,
to configure the LCA's on an ERPB.