D_Card  Aperture Table
         -------------------------


Aperture Table for all plots EXCEPT the two Solder Masks (files 9 and 10)

                                                Height(Y)    Thermal
Dcode        Shape       Type      Width(X)     Diameter     Relief
-----     ---------     ------     --------     --------     -------
10        circle        trace                     0.050
11        circle        trace                     0.012
12        circle        trace                     0.020
13        circle        trace                     0.100
14        circle        flash                     0.033
15        circle        flash                     0.060
16        circle        trace                     0.010
17        rectangle     flash        0.106        0.110
18        rectangle     flash        0.070        0.126
19        rectangle     flash        0.063        0.063

70        rectangle     flash        0.025        0.080
71        rectangle     flash        0.080        0.025

20        circle        flash                     0.057
21        circle        flash                     0.057       true
22        circle        flash                     0.084
23        circle        flash                     0.084       true
24        circle        flash                     0.150


"D" Code 21 is a Thermal Relief Aperture
  This thermal relief consists of a  0.033"  diameter inner pad followed
  by a  0.012"  wide air gap around this pad.  This makes the full outer
  diameter  0.057".  The air gap is crossed by 4 copper ties.  Each tie
  is  0.012" wide.   The ties run at 45 degrees to the X and Y axis.


"D" Code 23 is a Thermal Relief Aperture
  This thermal relief consists of a  0.060"  diameter inner pad followed
  by a  0.012"  wide air gap around this pad.  This makes the full outer
  diameter  0.084".  The air gap is crossed by 4 copper ties.  Each tie
  is  0.012" wide.   The ties run at 45 degrees to the X and Y axis.



Aperture Table for ONLY the two Solder Mask plots (files 9 and 10)
                  ------

                                                 Height(Y)
Dcode        Shape       Type      Width(X)     or Diameter
-----     ---------     ------     --------     -----------
11        circle        trace                      0.012
15        circle        flash                      0.065
16        circle        trace                      0.010
17        rectangle     flash        0.111         0.115
18        rectangle     flash        0.075         0.131
19        rectangle     flash        0.068         0.068
70        rectangle     flash        0.030         0.085
71        rectangle     flash        0.085         0.030




      ARTWORK FORMAT
  --------------------
Photoplotter coordinate mode is absolute

Photoplotter does not support circular interpolation
Arcs and circles are interpolated by 8 segments


Photoplotter supports Gerber G code

Photoplotter supports inch units
Scale is  1.000

Data format  2.3

Photoplotter modal coordinate is off

Photoplotter modal shutter open(D01) is off

Leading zeros are present

Trailing zeros are present

Record length of the artwork output file is   80
Film size is(width by height) :   16.000000  by    20.000000
Automatic offset specified will center board artwork on film sheet
Distance from film(0,0) to board origin is(x,y):    3.000000 ,   8.000000
Panel artwork offset is(0 ,0).
Photoplotter command block end char is   '*'
Photoplotter machine stop code is   'M02'