To Do List
                        --------------

                                                       Rev.  25-SEPT-1997


1. Electronics Box
      Cable Clamps
      Air Duct Connection
      Wiring Cables inside the Electronics Box and their toroids


2. Blower
      Mounting,  Finger Guard,  Air Duct Connection,  Power Cord
      Air Duct


3. Power Supply for VME Equipment
      Standard D-Zero Supply but must add +- 12V  200 mA supplies


4. Power Supply, Analog,  for Camera

      -4.5V_D,   -2.0V_D,   +5.0V_D,       -9V_A,   +9V_A
      --------   --------   --------       ------   ------
       0.66 A     1.75 A     0.70 A        0.71 A   1.02 A   <-- Actual Used
       1.00 A     2.65 A     1.10 A        1.10 A   1.55 A   <-- Min Supply

      Mounting Box
      Isolation Transformer
      Power Cable(s),  Power Connectors
      Tantalum capacitors for remote sense stability
      Power Cord and Power Inlet


5. FPGA Programming
      Board Support FPGA
      Array #? FPGA


6. 68k Code and Issues
      Code to load FPGA Configurations
      Code to set Array operating parameters
      Diagnostics Code ?
      Obtain 1 or 2 MVME-133A-20 modules


7. Connection to Sun
      EDT Card
      Software
      Cables


8. Dewar
      Rock Board
      Internal Cables
      Array IC



                          To Do List
                        --------------

                                                       Rev.  13-JAN-1998

1. Verify proper Analog Processor operation with current 3rd stage offsets.

2. Prep spare A-Cards for use.

3. Collect toroid inductors and grounding straps for the servo motors.

4. Collect the spare parts that will go to Panama.
     Spare Cards
     Spare small Components
     Spare Power Supplies

5. Make a guard bracket for the Front Paddle Board.

6. Make an MSA4 configuration to sent incrementing values to EDT.

7. Make a spare ROCK card ??

8. Prep a spare M-Card for use ??