M-Card  Aperture Table
           ---------------------------


 Aperture Table for all plots for the  M-Card
----------------------------------------------


Dcode      Shape       Type      Diameter
-----     ------       -----     --------
  10      circle       trace       0.010
  11      circle       trace       0.016
  14      circle       flash       0.010
  15      circle       flash       0.084
  16      circle       trace       0.050
  21      circle       flash       0.065
  22      circle       flash       0.400


D-Code 14  is flashed as 10 mils.  This just shows the location of pins
           that use this D-Code.  These pins are fully buried in the
           surrounding Gnd plane.  There is no Thermal Relief.  These pins
           connect to the surrounding Gnd plane.

D-Code 15  is flashed as 60 mil copper pad surrounded by a 12 mil wide
           air gap.  This makes the outer diameter of this flash 84 mils.
           The 12 mil wide air gap fully isolates the 60 mil pad from the
           surrounding Gnd plane.  These pins do not connect to the
           surrounding Gnd plane.



      ARTWORK FORMAT
    -----------------

Photoplotter coordinate mode is absolute
Photoplotter does not support circular interpolation
Arcs and circles are interpolated by 8 segments
Photoplotter supports Gerber G code
Photoplotter supports inch units
Scale is  1.000
Data format  2.3
Photoplotter modal coordinate is off
Photoplotter modal shutter open(D01) is off
Leading zeros are present
Trailing zeros are present
Record length of the artwork output file is   80
Film size is(width by height) :   16.000000  by    20.000000
Automatic offset specified will center board artwork on film sheet
Distance from film(0,0) to board origin is(x,y):    3.000000 ,   7.000000
Panel artwork offset is(0 ,0).
Photoplotter command block end char is   '*'
Photoplotter machine stop code is   'M02'